Welcome

#1-Old hole #3 (Sure..) It stays the same essentially, we clearout to the NW of the hole, creating a path to the new #2, which is essentially a lower pad than the existing one more coming out of the woods, and then playing to the original new 1 short, or short 2….

#2-new hole, eradicate honey suckle, new pad, clear out path through the gap to throw to old #1 short, or #2 short, even #2 long can be used…..

#3-Tee from the road and go over #2 current pad, eradicate all of the honeysuckle, initial short pin will be to the big tree that we want to expose…Initially we can create w path to the existing trail to get to the lower tee pad, eventually will want to turn that hole backwards and tee from above and go lower towards the pad, open up the hillside, exposing the rock all throughout there for everyone to enjoy. This should also allow the existing bike trail to remain without alterations to it from all angles….

#4-Use existing for now, but this needs to be reversed. This entire area was once cleared out with the rock face exposed, we need to get back to that and going in reverse also enables us to expose other rock face along the cliff side, giving the true definition of the park and incorporating some other elevation potentials within the park.

#5-Continue to clean/clear existing hole

#6-Continue to clean/clear existing hole, the new placement deep need MAJOR clean up and clearing around the entire pin area

#7-Continue to clean/clear existing hole

#8-New hole much clearing and cleaning out, wraps through the woods need an egress/ingress here that would align with the work being done along the water. This hole would have short and long features to help, but would be tight and technical through the woods. Removal of Honeysuckle and placement of boulders is key to this hole.

#9-New hole, this hole shouldn’t require much, but will have a potential dropoff to the right, need to ensure that the pin is located at the right spot for the short pin. The LONG pin will be placed around where the existing trail head for the course comes up and out.

#10-continue to clean/clear existing hole (Much needed at the exposure of the cliffs all along this and these holes.

#11- continue to clean/clear existing hole (Much needed at the exposure of the cliffs all along this and these holes.

#12- continue to clean/clear existing hole (Much needed at the exposure of the cliffs all along this and these holes. On this hole, would like to see the water from the walk, thinning and clearing out the honeysuckle on the side will enable a better view of the cliffs from the water as well as incorporate a better visual for disc golfers, and bike riders along the trail.

#13-Existing hole, clear up and expose the wrought iron fence.

#14- Existing hole, clear up and expose the wrought iron fence.

#15- Existing hole, clear up and expose the wrought iron fence.

#16-Existing hole, we need more trees…..on this and the open area….

#17-Existing hole, clean/clear

#18-Existing hole, this hole needs to be better to deter dumping, the long placement needs to be cleared out more, a downed tree was put in the long pin location.

We need (stairs) egress/ingress on the following:

#5-down from the throw to the fairway, after the pin is finished to the #6 tee pad, the #6 tee pad needs to be elevated as the runoff continues to cover the existing pad.

#6-up the hill off the pad can use a better way to get up.

#8-This new pin will need a few areas to get up a step, and then to get up to the road from the pins on the long placement